A Japanese seaplane tender sunk in 1944, lying on her side 36 m down.
The ship that explains why divers know the name Coron. It is also the one place on this list a visitor without a diving certificate cannot see at all.
- Time needed
- About 60 min in the water
- Opening hours
- Set by the dive boat. The run west from the town takes about an hour each way.
- Admission
- A dive-boat fare with a certified operator; there is no way to visit without diving.
- From the Coron cruise port
- about 25 kmStraight line; the road is longer.
At a glance
- A Japanese Navy seaplane tender, 114.8 m long, commissioned on 29 April 1942
- Her job was to carry, lift and service a large flying boat with the crane on her deck
- Sunk on 24 September 1944 by aircraft of United States Task Force 38, a day or two after she anchored here
- Lies on her port side; dive guides put the bottom at about 36 m and the shallowest steel around 20 m
- The crane is still there, and it is the single thing divers come to see
- A dive, not a snorkel — operators ask for an advanced certificate, and often nitrox
About Akitsushima Wreck
Akitsushima was not a warship in the ordinary sense. She was a seaplane tender: her purpose was to carry a single large flying boat, lift it out of the water with the crane on her after deck, service it and put it back. She was laid down in October 1940, launched on 25 July 1941 and commissioned on 29 April 1942, and she was 114.8 metres long and about 4,650 tons standard.
She anchored in Coron Bay in the last days of September 1944 — Wikipedia says the 23rd, Pacific Wrecks the 22nd. On the morning of the 24th, aircraft from the carriers of the United States Task Force 38 arrived over the bay, far beyond where Japanese commanders expected carrier aircraft to be able to reach, and sank her along with most of the fleet sheltering here. The wartime report fixed her loss at 11 degrees 59 minutes north, 120 degrees 02 minutes east; the wreck divers actually visit lies about six kilometres west of that, which is the position used here.
Today she lies on her port side. Dive guides give the bottom at about 36 metres and the shallowest steel at around 20, with figures quoted as high as 38; the spread is normal for a wreck this size on a sloping bottom. The crane that defined her is still standing, and it is what divers describe when they come up. This is a dive and nothing else: operators ask for an advanced certificate, often suggest nitrox for the bottom time, and will not take a swim-through inside the hull without a wreck qualification. If you are not diving, the Lusong gunboat and the shallow end of the Skeleton Wreck are what you can actually see.
Visiting Akitsushima Wreck
Good to know
Places near Akitsushima Wreck
Akitsushima Wreck: common questions
How long do you need at Akitsushima Wreck?
About 60 min in the water
What are the opening hours of Akitsushima Wreck?
Set by the dive boat. The run west from the town takes about an hour each way. Weather and visibility. There is no schedule to be closed.
Is there an admission fee at Akitsushima Wreck?
A dive-boat fare with a certified operator; there is no way to visit without diving.
How far is Akitsushima Wreck from the Coron cruise port?
It is about 25 km from the Coron cruise port in a straight line. The road is longer, and the drive depends on traffic.
How much walking is there at Akitsushima Wreck?
None. This is a boat dive in open water with no shore access.
From people who went
Nobody has written here yet. If you go, leave a line — the next ship reads it.
This place has the writing but not the recording.
CYC Beach
Banol Beach